700DFC.. Head question.. Grip Arms..

[Geardaddy]

Q for you guys who have finished your 700 DFC's.. I seem to run into this problem with EVERY align heli I've built, and so far, this one is no exception.. When assembling the main rotor head, the DFC Link Rod A and ball links at the swash.. Respecting the fact that the "A" needs to be facing outward, I can't get both sides completely even.. Full turn on either puts it out of whack respective to the other side.. Got them to within .15mm of each other.. Is that close enough, or is there some super secret double probation trick that I don't know about? Seems like I've gotten other heli's as close as possible, and then forgotten about it.. Imagine this will be the same, but I really want this heli to be as tight as possible!

Cheers!

[rcflyerheli]

Place a link driver the size of the blade grip bolts in the grip bolt holes and sight on it to the main shaft. If it is not parallel, adjust the plastic link until it is. My two DFCs were able to get completely parallel with the A on the link facing out.

If both drivers are parallel, the blade grips are at "0" and you are ready to rumble.