Scorpion 4025 for 550SE

[firemedic295]

Hi guys I am planing on buying a 550SE my 1st mikado. looking forward to it. I also have a quick question. Can I use a regular 4025 with a 5mm shaft?
Thanks All.

[volar]

Motor mount 30mm, as long as your 4025 has 30mm your good.
5mm shaft ok.
The Mikado edition 4025 comes with 5mm shaft, 25/30mm bolt pattern.

http://shop.mikadousa.com/04236-Meta...0mm_p_341.html

[firemedic295]

This is the motor I am getting.

http://innov8tivedesigns.com/parts/b...s-motor-kv-730

And this is the mikado motor.

http://shop.mikadousa.com/04349-Moto...100_p_402.html

Shaft length are the same but I am wondering if it will work using the spacer?

Thanks.

[volar]

Kit comes with 5mm counter bearing, need to replace with 6mm for that motor.
request a change when ordering or you can replace bearing in housing.

http://shop.mikadousa.com/04373-Coun...6mm_p_420.html

You have limited options with the 6mm herringbone pinions for mod .07, some have gone to mod1 gearing.
I have the sx and was going your route as well but decided to stick with the mod .07 gearing, 5mm motor shaft.