10 CHG Assigning switch for nav lights

[davo53]

Hi , l have 10CHG radio and can someone help me, l am running a 7Ch R617FS Rx, and l am using ch7 on rx to operate my nav lights, l am having problems to assing ch 7on rx to a switch to make it operate to allow me to turn the nav lights on and off, is it possible,


Regards Dave

[speaker]

Check if the governor function is active. That could be the reason for your problems.

Then just set a switch to control ch 7. Think it's under auxilary channels.

It should definately be possible if the nav lights can be switched on and of by a channel.

[davo53]

Originally Posted by speaker

Check if the governor function is active. That could be the reason for your problems.

Then just set a switch to control ch 7. Think it's under auxilary channels.

It should definately be possible if the nav lights can be switched on and of by a channel.

Hi Gov is INH tried that still cannot get it to work ,


Davo

[speaker]

Go in to the servo monitor and check the output to the channel. You might have to reverse the channel if you are using a 2 pos switch. Check your endpoints too. Should be at 100.

You are shure the lights are switchable?