03-09-2010, 07:54 PM
|
#1 (permalink)
|
Registered Users
|
Has any one had this problem with a 7CHP
I have a 7chp specturmized, I have a spectrum module in the radio, I have a spectrum rx in each heli. It's been doing fine for about 13 mo. I went flying Sunday everything was fine, went home I didn't do anything to the radio, I always check the helis to make sure nothing is loose or getting too sloppy after flying. I did not change anything on the helis. Today I went flying the Trex 450 was out of trim, I worked half the flight just trimming the heli, as I was coming in to land it was out of trim again. I looked over the heli could not find anything loose or out of tolerance. I know when something like this happens something is not right, so I put the 450 up until I could check everything. I brought the Trex 600n out, went into a hover it also was out of trim, I use the same radio for both helis. I kept in a hover to trim the heli it also did not stay in trim. I took the 450 and rebound it, still it would not stay in trim. Is it something with my radio?
PS sorry if this issue has already been posted I searched could find anything on it..
Trex 450, Trex 600n nothing fancy...
__________________
Spin em Hard Fly em Low if it hits watch which way the parts go.
|
|
|