2 axis gimbal question

[shaunmed]

I recently purchased an innexpensive 2-axis gimbal from eBay as pictured below. It did not come with any documentation and I was wondering if anybody knew A good site for resources regarding these units.

Mainly I am trying to figure out what power source it requires. Its power cable looks like a 2 pronged JST.

Thank you very much.

[Goldenhour]

Not sure of the voltage that powers that. Looks like a JST connector. MIne takes 11.1 volts, 3S.
I just bought one for $89 with free shipping on ebay and the Chinese guy had already dialed it in. I just plug it in and it works!!
Have you tried powering it up? It must be kept VERY still and level while it powers up. That takes about 6 seconds and the gopro must be on the gimbal as well. After that it should work. If not there is plenty of open source software for it.

[shaunmed]

i have to fashion some kind of adapter bc my 3S batteries have a 4 prong JST and this thing has only 2 prongs. hope i dont fry it!

[Goldenhour]

Make damned sure of your input voltage.
And that your polarity is absolutely correct.

[shaunmed]

there's only 2 wires on one and isnt black always ground?!

[Goldenhour]

Yes