WR bec

[BTB]

Im almost done wiring up my 600se and I have run in to a small problem. I cant find a good place on the frame to mount the hercules bec. I have been sitting here looking at the heli for a hour and im stumped. Where are you guys mounting your WR bec's?

[ChrisH]

You can mount it flat in the cavity in front of the motor (inside the frame), or I've also seen it mounted on the side of the frame at the rear.

[Ah Clem]

I will have to look at mine-I think it is on the side frame, facing out. Not pretty, but WR states that it should be in a place where air can flow over it.

I take them at their word.

[BTB]

Originally Posted by ChrisH

You can mount it flat in the cavity in front of the motor (inside the frame), or I've also seen it mounted on the side of the frame at the rear.

Sorry I should have said I am using the carbon frame so the layout is a little different. I cant put it in front of the motor, thats where im going to stick the hw cap pack.

Originally Posted by Ah Clem

I will have to look at mine-I think it is on the side frame, facing out. Not pretty, but WR states that it should be in a place where air can flow over it. I take them at their word.

Im trying to find a good spot to keep the bec cool. Its hard with these short output wires. If I ordered a heli jive I woldnt be having these problems.. Lol

[BTB]

I found a spot to mount the bec, thanks for the help guys..