V450D03 Mode Change Slams Down

[jrbbikerx]

So took an out of the box v450d03 for a spin

When I tried switching between normal and ST-1 and ST-2 flight the chopper slammed down into the ground, even when I was already above half throttle.

I went through the set-up and everything seemed ok. Note, I could not figure out how to see the individual pitch curves for each mode on the Devo7...

Everything is 100% stock but I feel like it shouldn't plunge down when switching between modes when above half throttle...or is it me?

Thanks!

[oxide1]

sounds like you hav a problem with your pitch curves, can you post what you have set for normal, st1, and st2 mode? Might help with figuring out what is going on.

[Bill_Van]

Originally Posted by jrbbikerx

So took an out of the box v450d03 for a spin

When I tried switching between normal and ST-1 and ST-2 flight the chopper slammed down into the ground, even when I was already above half throttle.

I went through the set-up and everything seemed ok. Note, I could not figure out how to see the individual pitch curves for each mode on the Devo7...

Everything is 100% stock but I feel like it shouldn't plunge down when switching between modes when above half throttle...or is it me?

Thanks!

If you have not solved this..... google Devo 7 settings on You-Tube and you will find a video showing how to set the pitch and other parameters. Your issue is definitely a pitch curve setting and can be easily solved with the proper adjustment. More than likely, there is too much negative pitch set when the stick is a 50%. Pitch should be at 0% when at halfway point with left stick. Then, negative pitch should increase as the stick is lowered. Back to 0% when returned to half way point!