JIVE PRO 120HV iddle up problem!!

[luckyhs]

Hi guys,
Just a little question, i have setup my JIVE PRO 120HV with mode 4, but when i change from normal to iddle up 1 and iddle up 2, the tail give a little kick from headspeed change, where can i program it to don't gove this kick in headspeed change, i'm using the progdisc, now there is a lot of informations in expert mode that i don't know how to use.
I have the gov. Mode in ON
Thanks
Luciano

[Wh1teAfr1can]

Originally Posted by luckyhs

Hi guys,
Just a little question, i have setup my JIVE PRO 120HV with mode 4, but when i change from normal to iddle up 1 and iddle up 2, the tail give a little kick from headspeed change, where can i program it to don't gove this kick in headspeed change, i'm using the progdisc, now there is a lot of informations in expert mode that i don't know how to use.
I have the gov. Mode in ON
Thanks
Luciano

Adjust the slew rates to the max setting they change how fast it will increase the motor rpm on throttle changes

Can you also link your setup heli and the way you have your throttle curves

[luckyhs]

Richard,
Where can i set this slew rates?? Where is this parameter?
I use flat curves on each iddle's
52% normal
65% iddle up 1
80 % iddle up 2
All flat curves on throttle, using JR 28X

[Vinger]

In the K-Config program under Expert parameters, there are both positive and negative slew rates, you want to increase the positive one to lenghten the time it takes to ramp up to a higher rpm. You need either the ProgDisc or ProgUnit to do this.