Need a tutor

rkopf · 06-01-2012, 02:34 PM

Hi,

Is there anyone near Danbury CT that I could hire that would be willing to tutor me on the 14mz?

I have a model or 2 (multirotors) that were set up for me, but I'm pretty much helpless on the programming of this thing and don't do well from reading the manual.

Thanks,
Rich

Phaedrus · 06-01-2012, 04:33 PM

I'm on the west coast, but these may help:

FAQ: http://www.futaba-rc.com/faq/faq-14mz.html

YouTube

YouTube

rkopf · 06-01-2012, 05:36 PM

Yep, I saw those when I was searching and they did help a bit, but I need someone to sit with me,and show me how to program some of the features as they relate to the hex's and quads I'm playing with.

Thanks for the help!

06-01-2012, 02:34 PM	#1
rkopf Registered Users Join Date: Jul 2010 Location: Oxford, CT	Need a tutor Hi, Is there anyone near Danbury CT that I could hire that would be willing to tutor me on the 14mz? I have a model or 2 (multirotors) that were set up for me, but I'm pretty much helpless on the programming of this thing and don't do well from reading the manual. Thanks, Rich

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-01-2012, 05:36 PM	#3
rkopf Registered Users Thread Starter Join Date: Jul 2010 Location: Oxford, CT	Yep, I saw those when I was searching and they did help a bit, but I need someone to sit with me,and show me how to program some of the features as they relate to the hex's and quads I'm playing with. Thanks for the help!