Fun, Learning, Friendship and Mutual Respect
START  HERE


Unregistered
Go Back   HeliFreak > R/C Electronics Support > Flight Stabilization


Flight Stabilization Flight Stabilization


Reply
 
Thread Tools Display Modes
Old 12-16-2012, 05:39 PM   #1
Camera Pilot
Registered Users
 

Join Date: Dec 2012
Location: USA -Eastern
Default APS Pulse Width Signals

Hello again,

Has anyone actually measured or know what the pulse width signals are for the receiver output going to the 3GX for the different modes using the APS system?

If it were known what the pulse width output for 3GX mode, APS mode, GPS mode and so on, it may eliminate some problems with crashes due to improper transmitter setup.

There are simple and inexpensive devices to measure the pulse width coming from the Rx.

I have an osilliscope and I'm sure there are others who do too.
The other devices are ESC programmers such as for Hacker motors.

That would be a good way of knowing if the transmitter is setup properly.

Anyone have any thoughts or info on this idea?

Thanks!

Joe
Camera Pilot is offline        Reply With Quote
Reply




Unregistered
Go Back   HeliFreak > R/C Electronics Support > Flight Stabilization


Flight Stabilization Flight Stabilization

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Copyright © 2004-2011 - William James - Helifreak.com