Logo 600 SX Vbar cyclic throw

Kalpazan · 12-20-2012, 12:18 PM

The geometry of my L6SX head seems somewhat correct. Collective throw is equal both directions, value is withing suggested range. However, the cyclic one is way off limit. I get 8 degrees at 123. I wonder if that is normal assuming SX has different geometry because of the lower head. Any thoughts ? What value did you get for exmaple ?

I tried to measure both with analog and digital pitch gauge and value is always too high.

edbme · 12-20-2012, 03:04 PM

I just finished building a 600sx and I ended up with 100 on the slider at 8 degrees. I went out 16 mm on the servo horns per the manual.

Kalpazan · 12-20-2012, 10:35 PM

Thanx, I'll look into my head once again as something must be wrong.

12-20-2012, 12:18 PM	#1
Kalpazan Registered Users Join Date: Dec 2010 Location: Burgas, Bulgaria	Logo 600 SX Vbar cyclic throw The geometry of my L6SX head seems somewhat correct. Collective throw is equal both directions, value is withing suggested range. However, the cyclic one is way off limit. I get 8 degrees at 123. I wonder if that is normal assuming SX has different geometry because of the lower head. Any thoughts ? What value did you get for exmaple ? I tried to measure both with analog and digital pitch gauge and value is always too high. __________________ LOGO 400SE: ICE75, 500MX, DS510M+DS650, VBAR 5.3 PRO, EDGE 473, KBDD 72.5 LOGO 600SX: JIVE 100LV, HKIII-4025-1100, BLS451+BLS251, VBAR 5.3 PRO, EDGE 600, EDGE 95

12-20-2012, 03:04 PM	#2
edbme Registered Users My HF Map location Join Date: Sep 2009 Location: richmond, ca.	I just finished building a 600sx and I ended up with 100 on the slider at 8 degrees. I went out 16 mm on the servo horns per the manual. __________________ logo 600 sx vbar, 500 vbar, 700n vbar The funny thing about common sense Is It's not very common.

12-20-2012, 10:35 PM	#3
Kalpazan Registered Users Thread Starter Join Date: Dec 2010 Location: Burgas, Bulgaria	Thanx, I'll look into my head once again as something must be wrong. __________________ LOGO 400SE: ICE75, 500MX, DS510M+DS650, VBAR 5.3 PRO, EDGE 473, KBDD 72.5 LOGO 600SX: JIVE 100LV, HKIII-4025-1100, BLS451+BLS251, VBAR 5.3 PRO, EDGE 600, EDGE 95

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode